VELOSTER(FS) >2013 > G 1.6 T-GDI > Suspension System > Front Suspension System > Sub Frame>Repair procedures  
Replacement
1.
Remove the front wheel & tire.

Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

Be careful not to damage to the hub bolts when removing the front wheel & tire.
2.
Disconnect the stabilizer link (B) with the front strut assembly (A) after loosening the nut.

Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

3.
Loosen the nut and then remove the tie-rod end (A) with the front axle (B).

Tightening torque :
23.5 ~ 33.3N.m(2.5 ~ 3.4kgf.m, 19.4 ~ 24.6lb-ft)

4.
Loosen the nut and then remove the lower arm (A).

Tightening torque :
78.5 ~ 88.3N.m(8.0 ~ 9.0kgf.m, 57.9 ~ 65.1lb-ft)

5.
Loosen the bolt (A) and then disconnect the universal joint assembly from the pinion of the steering gear box.

Tightening torque :
32.4 ~ 37.3N.m(3.3 ~ 3.8kgf.m, 23.9 ~ 27.5lb-ft)

Lock the steering wheel in the straight ahead position to prevent the damage of the clock spring inner cable when you handle the steering wheel.
Must be replaced with new bolts when assembling. (SEAL-LOCK has been processed)
6.
Remove the rubber hanger (A).

7.
Loosen the roll rod (A) mounting bolts and nuts.

Tightening torque :
53.9 ~ 63.7N.m(5.5 ~ 6.5kgf.m, 39.8 ~ 47.0lb-ft)

8.
Loosen the bolts & nuts and then remove the front sub frame (A).

Tightening torque :
Sub frame mounting bolt & nut
156.9 ~ 176.5N.m(16.0 ~ 18.0kgf.m, 115.7 ~ 130.2lb-ft)
Sub frame stay mounting bolt
44.1 ~ 53.9N.m(4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)

9.
Remove the lower arm.
(Refer to SS group - "Lower Arm")
10.
Remove the stabilizer bar.
(Refer to SS group - Stabilizer Bar")
11.
Remove the steering gear box.
(Refer to ST group - "Steering Gear Box")
12.
Installation is the reverse of removal.
13.
Check the wheel alignment.
(Refer to SS group - "Tires/Wheels")