Inspection

1.	Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.

Installation

• Install the component with the specified torques. • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

• Apply the engine oil to the O-ring.

• Insert the sensor in the installation hole and be careful not to damage.

1.	Installation is reverse of removal. Crankshaft position sensor installation bolt: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)