VELOSTER(FS) >2013 > G 1.6 T-GDI > Engine Mechanical System > Intake And Exhaust System > Intercooler Pipe & Hose>Repair procedures  
Removal and Installation
1.
Remove the air duct and air cleaner assembly.
(Refer to Intake and Exhaust System - "Air Cleaner")
2.
Remove the intercooler outlet hose(A).

Tightening torque :
4.9 ~ 6.8N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)

3.
Remove the intercooler inlet hose & pipe(A).

Tightening torque
Bolt :
19.6 ~ 26.4N.m (2.0 ~ 2.7 kgf.m, 14.4 ~ 19.5 lb-ft)
Clamp :
4.9 ~ 6.8N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)

4.
Install in the reverse order of removal.
Match the marking part of hose and marking part of throttle body, compressor .
Match the pipe stopper and hose marking.
When the band part have been place on the top of position mark of hose, install to not exceed the mark.
Tighten until the torque control cap is released. If there is no the torque control cap, tighten as specified torque.